我想要設定openocd為stlink(sudo./configure --enable-stlink)結果報錯：configure: error: libusb-1.x is required for the ST-Link JTAG Programmer。
接著我安裝libusb-1.0-0-dev（sudo apt-get install libusb-1.0.0-dev），結果報錯：The following packages have unmet dependencies:
libusb-1.0-0-dev : Depends: libusb-1.0-0 (= 2:1.0.20-1) but 2:1.0.22-2 is to be installed
Recommends: libusb-1.0-doc but it is not going to be installed
E: Unable to correct problems, you have held broken packages.
。請問我要怎么把這個已經安裝的libusb版本洗掉換成我想要的
轉載請註明出處，本文鏈接：https://www.uj5u.com/caozuo/32742.html
標籤：專題技術討論區
上一篇：ftp