各位老師，本月公司升級了寬帶，原來電信給的子網掩碼是30位，現在升級后掩碼是29位，現在IP地址比之前多了，我在路由器上配置了外網地址池，希望內網的客戶端能從外網地址池里拿地址上網，但是配置好之后 show ip nat trans,地址轉換的都是使用的地址池里第一個地址，后面的地址沒有被翻譯，請教各位老師指點，配置如下：
Router#sh run int gi0/0
Building configuration...
Current configuration : 201 bytes
!
interface GigabitEthernet0/0
description ***** To ISP *****
ip address 215.29.107.166 255.255.255.248
ip access-group AV in
ip nat outside
ip virtual-reassembly in
duplex auto
speed auto
end
Router#sh run int gi0/1
Building configuration...
Current configuration : 176 bytes
!
interface GigabitEthernet0/1
description ***** To Switch *****
ip address 172.16.0.254 255.255.255.0
ip nat inside
ip virtual-reassembly in
duplex auto
speed auto
end
Router#sh run | se nat
ip nat outside
ip nat inside
ip nat pool Global 215.29.107.162 215.29.107.167 netmask 255.255.255.248
ip nat inside source list NAT pool Global overload
Router#sh ip access-list
Standard IP access list NAT
10 permit 172.16.0.0, wildcard bits 0.0.0.255 (88092 matches)
轉載請註明出處，本文鏈接：https://www.uj5u.com/qiye/15069.html
標籤：企業信息化
上一篇：ckan安裝部署后，除了管理員用戶能創建資料集，別的用戶分配完管理員權限以后無法創建，請問各位大佬，是怎么回事啊