初次弄高通芯片，我想設定GPIO11為輸出，我已經設定GPIO_OE暫存器，但這個FUNCTION3暫存器如何設定啊？真心沒看明白，
uj5u.com熱心網友回復：
可以參考一下blog：http://blog.csdn.net/Joymine/article/details/48161895uj5u.com熱心網友回復：
//add by buqing.wang start#define GPIO_FLASH_NOW_ID 31 //flash gpio id
#define GPIO_FLASH_COUNT 10 // 10 cycle
#define HWREG_OUT(address, value) (*((volatile uint32_t*)(address)) = (value) )// Write to hardware register
#define HWREG_IN(address) (*((volatile uint32_t*)(address))) // Read from hardware register
//add by buwing.wang end
uj5u.com熱心網友回復：
你可以參考下以下鏈接，里面講的很清楚：https://blog.csdn.net/ldinvicible/article/details/52421640?depth_1-utm_source=distribute.pc_relevant.none-task&utm_source=distribute.pc_relevant.none-task
轉載請註明出處，本文鏈接：https://www.uj5u.com/qita/100934.html
標籤：Qualcomm開發